Aufrufe
vor 1 Jahr

User Manual Triebel Reloading Dies

  • Text
  • Cartridge
  • Spindle
  • Sizer
  • Interior
  • Seater
  • Sizing
  • Holder
  • Sleeve
  • Ejector
  • Expander
  • Manual
  • Triebel
  • Reloading
  • Guntools.de
Unser manual and safety instructions for original Triebel Reloading dies.

Spindle with interior

Spindle with interior expander for short cartridge cases The knurled sleeve is no longer needed for the version for short cartridge cases. Sizing cartridge cases The new interior expander performs the clamping function in this case. The interior expander for short cartridge cases has an unpolished collar. 1 Counter nut for stop 2 Stop for neck sizer ring 4 Interior expander 5 Ejector pin 3 Spindle www.triebel-guntools.de 14/37 User Manual-2.0

Sizing cartridge cases Setting the full-length die Description Set the correct case holder in the press punch. Move the press punch to the top position. Screw the Full-length die into the press until the outer die body contacts the case holder. Measure the height of the cartridge base and set the spindle so that it does not contact the cartridge base. Position the spindle using the interior sizer and the ejector pin so that it is located in the center. Set the interior sizer so that it does not sit too far up on the spindle. Grease the exterior of the cartridge case and the interior of the case neck (e.g., with a grease pad) and insert it into the case holder. During initial sizing, only insert the cartridge case 5-10 mm, then retract it and size the entire cartridge. Actuate the press lever to move the cartridge case upwards. Move the press lever back again and remove the cartridge case. Check the dimensional accuracy of the cartridge case. Notes The case holder must fit as precisely as possible. Since the edges of the cartridge cases of different manufacturers can have different dimensions, case holders that are adapted to this condition also exist. If the edge of the cartridge is not guided correctly, there is a risk of it rupturing. A considerable amount of effort is then required to remove the cartridge case. Trial and error is usually the only approach here. If an accident of this type should happen to you, please contact our customer service so that we can rescue the die with as little damage as possible. When the cartridge case is inserted, there must be a gap between the case holder and the die body at top dead center. This prevents a pressure buildup that could result in damage. Check the distance. The spindle could be damaged if there is contact with the cartridge base. The spindle must not contact the cartridge base. The spindle and the knurled sleeve could be damaged. The interior sizer could reach into the area of the case neck, in particular on cartridge cases with a very short powder chamber. The interior sizer must be positioned so that it slides without resistance when the cartridge case moves upwards and that it expands the cartridge case only during the downward stroke. Cartridge cases that have not been greased may jam in the die. Too much grease on cartridge cases can result in dents in the cartridge cases. This optimally distributes the lubrication film in the Full-length die. The cartridge case is inserted into the Full-length die and pressed into the Full-length die through the dead center of the press. Clean the cartridge case after sizing. The press and the Full-length die are now set and you can size additional cartridge cases. www.triebel-guntools.de 15/37 User Manual-2.0

© Copyright 2017.Triebel Waffenwerkzeuge GmbH. Alle Rechte